This kit is a bolt on rear disc brake conversion for the Samurai, Sierra or SJ413

It uses standard Suzuki front brake rotors, and brake calipers from a Mitsubishi Galant, which include a handbrake in the caliper and are sized correctly to work without an additional proportioning valve. 

This kit comes in three styles for NT (narrow track), WT (wide track) or SJ80 coil spring vehicles. 

Kit contains: 

2 caliper mounting bracket 
2 disc mounting adaptors 
handbrake cable bracket 
threaded handbrake adjuster 
2 brake hose brackets 
1 clevis pin 
1 split pin 
10 Suzuki wheel studs 
11 M8 bolts 
11 nyloc nuts 
4 caliper mounting bolts 
4 spring washers 
2 Hose retaining clips 
3-way T piece 
Brake lines 
Instructions 

Parts required: 

Mitsubishi Galant 89-92 (E33) rear calipers with brake hoses, plus handbrake cables, handbrake lever balance bar and adjuster nut. 

Suzuki Samurai / Sierra / SJ413 front discs 
Brake fluid 
Silicone sealer / gasket maker.

The calipers are usually available rebuilt from Rockauto in the US under the following part numbers:

CARDONE 19B1192, CARDONE 19B1193 
CENTRIC 14146511, CENTRIC 14146512 
CENTRIC 14146517, CENTRIC 14146518

A lot of the reconditioned calipers don't come with the special banjo fitting where the brake hose connects to the caliper. You can use SUNSONG 2203882 from an Isuzu Amigo / pickup if you don’t have the banjo block fitting. This hose has a banjo on the end and will bolt straight to the caliper.

Part number BC52039 and BC52049 or BC94067 and BC94082 for the park brake cables.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: